Chopping Logs

Cutting of walls 'in the leg' can be simple and sophisticated. In the first case, the push-pins in the second - the root. Technology cabin walls 'in paw' is different in that the logs do not protrude beyond the corners of the framework. Such technology cutting call the house without a remainder, it is more complicated and time-consuming compared to the chopping 'the bowl' and requires a skilled approach. All elements of the log with this method are adjusted packing very carefully and any deviation can lead to the fact that the house would be purged and no seals will not help get rid of this drawback. Begin cutting with the fact that the ends of the logs carefully mark the beginning of the log, which peak in the upper section has a the smallest diameter.

This is a log in the future should be the benchmark and the size of its 'feet' to mark end of the remaining logs. Any deviations in the markup 'legs' can lead to a breach of vertical angles log and their sealing, and therefore to the markup, and even more so to the processing of 'legs', should be treated with maximum care. One edge, designed for the inside of the walls, sculptured on the entire length of the logs. Kant, the opposite Inland, hewing to a length equal to one and a half - twice the diameter of the logs. At this end of the logs hewn on two parallel sides is called a 'dummy', formed at this plane - 'cheeks', and the raw convex surface - 'wane. " The two remaining edge bevel on the long, slightly larger diameter logs.

It is much easier and more convenient layout 'paws' to perform a special pattern, which is made by the procedure specified in the. For this on the piece of cardboard draw the circle for two identical templates. In this circle through its center from two mutually perpendicular diametral lines. By combining their points of intersection with the circle, get square. Then opposite sides of a square is marked in different proportions, 8 / 8 or 6 / 8 and 4 / 8, etc. The resulting patterns if they are made of paper, glued onto the base and cut out. In places where the vertical line ended, make notches, necessary for further marking the ends of logs. During the marking 'leg' pattern is applied to the face of the logs, combining cut-outs, with incised serifs on the ends of the logs above the vertical line of diameters and leads him to circuit. After proteski bokovinok logs rascherchivayut all facets of 'legs'. When the device 'legs' in the logs 22 cm thinner than the sides patterned squares divided not by 8, and 12 parts, and then dividing the proportion already looks like 8 / 12 to 6 / 12 and 6 / 12 4 / 12. 'Feet' prepare for all future log timbers, carefully adjusts them make control assembly blockhouse near the base and leave to dry for several months. Once the logs are dry, they are placed on the foundation, perform final assembly with a gasket between the heater and attach the plug-studs. Konopatku joints is carried out at the final assembly, and a year after that.