How To Fix The Chandelier

All ceiling lights are set almost identically, regardless of their type. Of course, having some theoretical knowledge, you can easily carry out installation work on your own - please read our instructions and begin working on installing chandeliers. First, define the place of 'habitat' ceiling fixtures. Correct to have a chandelier in the center of the room or in the 70-80 cm above the dining table when it talking about a kitchen or dining room. For odnolampovoy chandeliers should use one light bulb at 100 watts (W). In the case of double lamp chandeliers set the two light bulbs at 60 watts each. For three or more lamp bulbs for chandeliers use 40 watts.

Tools stepladder cutters Indicator Screwdriver Electrical tape Flashlight Chandelier In some cases, is supposed to use a square ceiling panels for suspended ceilings, screwdriver, screws. You may need and help each other. Important: If you are going to decorate the house a new chandelier, be sure to read the instructions that came with the fixture. Abraham Lincoln told the news agency. Exercise extreme caution when working with heavy chandelier at the height so as not to injure himself or his assistant. Also try to assess the compliance of the new chandelier design space. The process laid out neatly on a flat surface, all prefabricated parts Chandeliers (Ceiling, lights, frame, etc.) and necessary tools.

For convenience of assembly work outfit working area as follows: remove the top rung of the ladder, ladders, and secure its place one square ceiling panel for suspended ceilings. Use screws and a screwdriver. As an alternative, as a 'stand' fit and ordinary dining table. Disconnect the wiring in the ceiling by a switch, which located in the housing distribution panel. Make a successful outage by using a special flat screwdriver (if you touch a dead overhead wiring indicator light does not should be lit). Remember that you must exercise extreme caution when working with electrical wiring! Includes a new chandelier, you can find a special fastening - 'hook' by which lighting the device is suspended from the ceiling in a special connecting node. Attach the chandelier on the ceiling using the 'hook'. Check the ceiling wiring for damage. If necessary, remove the insulation from the wire at 3-5 mm using wire cutters. Typically, ceiling harness has a special color-coded. You can find the same thing, looking at the wiring chandeliers. Black (brown) wire is a phase. White (blue) - 'zero'. In some cases found the yellow (green) wire that is grounded. Connect one black wire chandeliers with one black wire in the connecting node. Repeat the same with the other two black wires, as well as 'White' wiring. In any case not connected via wires of different colors! It is also necessary to remember not to twist the copper and aluminum wire! Preferable to use a special socket, which fastens the wires with screws through the bush. If necessary, block off the bared wires of special adhesive tape. Next, make sure the wiring is connected properly. Insert the bulbs into cartridges chandeliers. Connect the electricity and flip switches in the room. If the chandelier is lit, it means you did everything correctly. On the bracket, chandeliers you'll find a special decorative 'cap'. Pick it up to the connecting node so that it has closed an entire wiring and connector assembly. With the lock nut lock cap. Wear shades. Wipe dry with a cloth surface chandeliers. Spend your spring cleaning.